Top seller
No results were found for the filter!
Tamper 2 click Tamper 2 click contains a levered D2HW-A221D switch by Omron , which outputs signal in both positions - pressed and released. Omron switches, also known as microswitches, are well renowned for their reliability and endurance. The PCB of...
₹1,369.00 *
Tamper click Tamper click is equipped with SDS001 , a low profile side-actuated detect switch, made by C&K company. This is a high-quality, low-current detection switch, which is designed in a form of a push button. The switch itself is very small -...
₹949.00 *
Keylock click Keylock click carries a processed sealed key lock mechanism that can be set in three different positions. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over the PWM, INT,...
₹2,629.00 *
TouchKey 2 click TouchKey 2 click has four capacitive pads powered by Microchip's ATtiny817 which has an integrated touch QTouch® controller. The click is designed to run on a 3.3V power supply. The four LEDs onboard the click indicate when the Key (Pad)...
₹1,679.00 *
ROTARY O click Rotary click carries a 15-pulse incremental rotary encoder with detents, surrounded by a ring of 16 orange LEDs. It’s a perfect solution for adding a precision input knob to your design. The encoder outputs A and B signals (out of phase...
₹1,259.00 *
SpeakUp 2 click SpeakUp learns from scratch, so you can make it understand your commands spoken in any language, dialect or slang. Using a simple interface on your computer, you record a word (up to 1 second) and assign it an instruction. Repeat for as...
₹3,569.00 *
Thumbwheel Click Thumbwheel click is a mikroBUS™ add-on board with a 10-position rotary sprocket connected to a 1-Wire 8-Channel Addressable Switch . The starting position of the switch is marked with a small notch on the PCB above the wheel. Printed...
₹3,049.00 *
Cap Extend click Cap Extend click is a mikroBUS add-on board with a SEMTECH SX8633 low power, capacitive button touch controller. It has 12 pins for connecting capacitive inputs (either touch-buttons or proximity sensors). Any sort of conductive object...
₹1,889.00 *
TouchClamp click TouchClamp click is a mikroBUS™ add-on board with NXP’s MPR121 proximity capacitive touch sensor controller. It has seven plated holes for clamps which can be used to connect any – literally any – conductive object in order to use it as...
₹949.00 *
IR Gesture click IR Gesture click is a mikroBUS add-on board that enables contactless gesture recognition, along with ambient light and proximity sensing capabilities with the APDS-9960 IC. This sensor integrates an LED and four directional photodiodes...
₹1,679.00 *
Button G click Button G click is the simplest solution for adding a single pushbutton to your design. The button itself is transparent, 6.8mm in diameter and has a green LED backlight. When pressed, it sends an interrupt signal to the target board...
₹1,039.00 *
TouchPad click Touchpad click is a capacitive touch input device driven by Microchip’s low-powered MTCH6102 controller. The touchpad surface is covered with a sheet of black plastic to demonstrate the chip’s support for cover layers (up to 3mm for...
₹1,579.00 *
SpeakUp 2 click Button Power ROTARY Y click ROTARY G click Joystick 2 PROXFUSION 2 Knob G Click CAP Wheel 2 TouchKey click Vibro Motor 2 Keylock 2 Click Tamper click Cap Extend 3 IR Gesture Cap Touch 5 Keylock click Button PLAY Saml Touch Button G click ROTARY O click Counter Click Touch Key 4 CapSense click TouchKey 3 Joystick click TouchPad click Fingerprint THUMBSTICK TouchKey 2 SpeakUp click Cap Touch 2 Cap Touch click 4x4 Key click CAP Slider 2 Button R click ROTARY B click Thumbwheel Power Reset SwipeSwitch ROTARY R click Tamper 2 click Cap Wheel click Button Y Click Cap Extend Button ALARM TouchClamp
Viewed