Features Mobile Mobile module 4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps 3GPP Release - Release 9 Status - Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI,...

Overview This cable is designed to work with our Micro Metal Gearmotor Encoders with top-entry connector and with side-entry connector . It consists of six 28 AWG color-coded wires that are terminated on one end by a female JST SH-type...

Features : 8 way operation . Fits metal control panels. Easy to operate, with high sensitivity. Specification : Top Ball Diameter: Approx. 35mm Total Size: Approx. 95x60x100mm Package includeds : 1 x Joystick

Improve your flight time with the upgraded battery for your Crazyflie 2.X! The 350 mAh battery boosts the hover-time to above 10 min. This upgrade battery is based on the “Tattu 350mAh 3.7V 30C 1S1P” cell and with some additional great...

With a new and improved design these propellers gives the Crazyflie a boost in efficiency. Both flight time and maximum thrust is increased with up to 15%! Specifications Diameter: 47 mm Pitch: 17 mm Material: PC Fits shaft: 0.8 mm...

Features: Low profile Gold plated Brass 50ohm impedance Designed to be easily connected into a breadboard for rapid development Critical component for Atlas Scientific Mini probes

Spare Crazyflie 2.X brushed coreless DC-motor. Mechanical specifications: Diameter: 7.0 mm Length: 16.0 mm Shaft length: 3.5 mm Shaft diameter: 0.8 mm Weight: 2.7 g Wire length: 32.0 mm Molex Picoblade 2P connector Electrical...

The 3003 - Phidget Cable is used to connect analog sensors to any Phidget with an analog input or VINT Hub port. Product Specifications Physical Properties Connector A Analog 3-Wire Connector B Analog 3-Wire Number of Conductors 3 Cable...

RFid click features CR95HF 13.56 MHz contactless transceiver as well as trace antenna. The click is designed to run on a 3.3V power supply only. It communicates with the target MCU via mikroBUS™ UART (TX, RX), SPI (MISO, MOSI, SCK, CS)...

Motor Connections These wheels are designed to press-fit securely onto the 3mm D output shafts on many of our gearmotors, including our micro metal gearmotors and our mini plastic gearmotors. They also work with our 35:1 and 115:1 15.5D...

These plastic mounting brackets allow you to easily and securely mount the ubiquitous 10 mm × 12 mm × 26 mm metal gearhead motors first popularized by Sanyo’s 12GN series (e.g. NA1S…NA3S), such as our micro metal gearmotors. We also...

Add quadrature encoders to your micro metal gearmotors ( extended back shaft version required) with this kit that uses a magnetic disc and hall effect sensors to provide 12 counts per revolution of the motor shaft. The sensors operate...