Top seller
No results were found for the filter!
RTC2 click RTC2 Click is an accessory board in mikroBus™ form factor. It features the DS1307 serial real-time clock (RTC). It is a low-power, full binary-coded decimal (BCD) clock/calendar with programmable square-wave output signal. Board uses I2C...
₹2,209.00 *
PLL click PLL click is a frequency multiplier which uses the Phase-Locked Loop (PLL) techniques to provide a high-frequency clock output from a cheap, standard fundamental mode crystal oscillator. In addition to this, PLL click also offers a...
₹2,239.00 *
Clock Gen 2 click Equipped with the NV memory, synchronous Output Enable and Power Down function, clock prescaler, spread-spectrum options for reducing EMI radiation, the high-quality SMA connector, and an industry-standard I2C communication interface,...
₹2,489.00 *
LED Flash 2 click LED Flash 2 click is a powerful flash/torch click, featuring the MIC2870 from Microchip , a high-efficiency flash LED driver, optimized for driving one or two high-brightness camera flash LEDs. The MIC2870 IC can drive one high...
₹2,869.00 *
7x10 B click 7x10 B click displays letters, numbers, and characters in a 7x5 font resolution. It carries a matrix of 70 blue LEDs driven by a pair of 8-bit serial-in, parallel-out shift registers, a Darlington Transistor array and a Johnson counter....
₹1,579.00 *
7x10 Y click 7x10 Y click displays letters, numbers, and characters in a 7x5 font resolution. It carries a matrix of 70 yellow LEDs driven by a pair of 8-bit serial-in, parallel-out shift registers, a Darlington Transistor array and a Johnson...
₹2,239.00 *
16x12 G click 16x12 G click carries a 16x12 LED display and the IS31FL3733 matrix driver. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over I2C interface, and the following pins on the...
₹4,489.00 *
UT-M 7-SEG R click UT-M 7-SEG R click carries two SMD ultra thin LED 7-SEG displays and the MAX6969 constant-current LED driver from Maxim Integrated. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target...
₹5,109.00 *
UT-L 7-SEG R click UT-L 7-SEG R click carries two SMD ultra thin (3.1mm) LED 7-SEG displays and the MAX6969 constant-current LED driver from Maxim Integrated. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target...
₹5,229.00 *
LED Flash click LED Flash click functions as a high power LED flash, and carries the CAT3224 flash LED driver. The click is designed to run on a 5V power supply. It communicates with the target microcontroller over the following pins on the mikroBUS™...
₹3,569.00 *
7-SEG RGB click 7-SEG RGB click carries a full-color single 7 segment digit display . The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over the CS, and PWM pin on the mikroBUS™ line. The...
₹6,479.00 *
7x10 G click 7x10 G click can be used for displaying letters on a display with 7x5 font resolution. It carries a matrix of 70 green LEDs driven by a pair of 8-bit serial-in, parallel-out shift registers, a Darlington Transistor array and a Johnson...
₹2,239.00 *
EERAM 3.3V IR Sense 2 Temp Hum 9 I2C Isolator 2 1-Wire I2C USB UART click 3G SARA click DALI 2 click 4-20 mA T click 13DOF Click Matrix RGB ATA6563 click Gyro 2 Click PWM 2 click Balancer 3 RS485 click 5V OBDII click Fan 6 click Expand 3 click Air quality 3 SQI FLASH click LED Flash click LLC SPI Click ATA663254 click Fan 3 click RadioStation MAC Address DC Motor 11 AM FM Click UART 1-Wire LLC-I2C Click Stepper 7 click UART Mux click FLICKER click MOTION click AudioAmp 4 MCP25625 click CAN Isolator Heart Rate 7 ATA6570 click H-Bridge 2 MCP2518FD click RS485 click DigiVref Click 6DOF IMU 11 LightRanger 4
Viewed