Riverdi click

₹949.00 *

Prices incl. VAT plus shipping costs

Ready to ship today,
Delivery time appr. 1-3 workdays

Order number: MIKROE-2100
Manufacturer product ID: MIKROE-2100

Riverdi click is an adapter for connecting Riverdi TFT displays to a mikroBUS socket. The... more

Close menu

Product information "Riverdi click"

Riverdi click is an adapter for connecting Riverdi TFT displays to a mikroBUS socket. The onboard zif20 connector allows you to interface between the target MCU and an FT8xx graphic controller on Riverdi displays. The click runs on either 3.3V or 5V power supply.

Note: Riverdi click comes with a flat flexible cable for the onboard zif20 connector.

I2C/SPI interface

Riverdi click can have either an I2C or an SPI interface. A set on onboard jumpers allows you to switch between these communication lines.

Specifications

Type	Adapter
Applications	Interfacing Riverdi HMI displays with mikroBUS™ compatible development boards
On-board modules	zif20 connector. FT8xx graphic controller
Key Features	SPI/I2C interface with selection jumpers
Key Benefits	Simplest way to interface a large number of TFT displays with mikroBUS™
Interface	GPIO,I2C,SPI
Input Voltage	3.3V or 5V
Compatibility	mikroBUS
Click board size	S (28.6 x 25.4 mm)

Pinout diagram

This table shows how the pinout on Riverdi click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes	Pin					Pin	Notes
	NC	1	AN	PWM	16	NC
Reset	RST	2	RST	INT	15	INT	Interrupt
Chip select	CS	3	CS	TX	14	NC
SPI clock	SCK	4	SCK	RX	13	NC
Master input slave output	MISO	5	MISO	SCL	12	SCL	SCL I2C line
Master output slave input	MOSI	6	MOSI	SDA	11	SDA	SDA I2C line
Power supply	+3.3V	7	3.3V	5V	10	+5V	Power supply
Ground	GND	8	GND	GND	9	GND	Ground

Jumpers and settings

Designator	Name	Description
J1	SCK/SCL	Select between SCL/SDK
J2	MISO/SDA	Select between MISO/SDA
J3	SPI/I2C	Select between SPI/I2C