Top seller
No results were found for the filter!
16x9 G click contains a green LED matrix and the IS31FL3731 audio modulated matrix LED driver. The dimension of the LED matrix is 16x9. Each LED can be controlled individually – both for on/off control and light intensity. The click is...
₹3,569.00 *
An OLED built in a button This board has a module that combines a button and a full color organic LED display, plus input/output screw terminals for connecting an external circuit (to toggle it on and off). The mechanical button itself...
₹10,399.00 *
Matrix G click is a mikroBUS add-on board with two green 5x7 matrices driven by two MAX7219 8-bit LED Display Drivers. The active area of each matrix is 7.62mm high and 5.08 mm wide. 7x5 is a standard resolution for displaying ASCII...
₹3,049.00 *
Matrix R click is a mikroBUS add-on board with two red 5x7 matrices driven by two MAX7219 8-bit LED Display Drivers. The active area of each matrix is 7.62mm high and 5.08 mm wide. 7x5 is a standard resolution for displaying ASCII...
₹3,049.00 *
Matrix RGB click is a mikroBUS™ add-on board powered by a 32-bit FT900 MCU designed specifically for powering 16x32 RGB LED matrices. The board has a 16 wire IDC connector for connecting to a single 16x32 LED panel; however, the firmware...
₹2,519.00 *
LED ring R click is a mikroBUS™ add-on board with a ring of 32 red LEDs driven by four 8-bit 74HC595 serial-in, parallel-out shift registers. The ring is 25mm in diameter. The click communicates with the target MCU through the mikroBUS™...
₹1,679.00 *
7x10 R click can be used for displaying letters on display with 7x5 font resolution. It carries a matrix of 70 red LEDs driven by a pair of 8-bit serial-in, parallel-out shift registers, a Darlington Transistor array and a Johnson...
₹1,579.00 *
4x4 RGB click carries a matrix of 16 WS2812 RGB LEDs and a MCP1826 low dropout regulator. These LEDs actually consist of three single colored LEDs (Red, Green and Blue), plus a control chip in a single package; various colors can be...
₹1,999.00 *
AlphaNum click is a simple solution for adding 14-segment alphanumeric display to your device. The board carries two TLC5926 16-bit Constant-Current LED sink Drivers as well as a dual character red LED 14-segment display (with two...
₹1,579.00 *
AlphaNum click is a simple solution for adding 14-segment alphanumeric display to your device. The board carries two TLC5926 16-bit Constant-Current LED sink Drivers as well as a dual character green LED 14-segment display (with two...
₹1,579.00 *
OLED C click lets you add a small but bright and crisp color OLED display to your design. It carries the PSP27801 OLED display, the same one that we have used on Hexiwear. The click is designed to run on 3.3V power supply only. It...
₹3,049.00 *
OLED W click carries a 96 x 39px white monochrome passive matrix OLED display. The display is bright, has a wide viewing angle and low power consumption. To drive the display, OLED W click features an SSD1306 controller. It's built-in...
₹2,519.00 *
OLED Switch UT-M 7-SEG R OLED W click BarGraph 3 LCD Mono Click TFT Board 7 Led ring R 8x8 G click 8x8 R click Mikromedia 4 AlphaNum R Matrix G click RGB Driver TFT Board 5 OLED B click 7-SEG RGB click Matrix R click 4Dot-Matrix R BIG 7-SEG R eINK Click UT-S 7-SEG R Next LCD mini Matrix RGB 8x8 B click 7x10 R click UT-L 7-SEG R 4X4 RGB click EVE Click BarGraph 2 7x10 Y click BarGraph click 16x12 G click LED Driver 7 7x10 B click 7x10 G click OLED C click OSD click 16x9 G click AlphaNum G 7seg click LED Flash click 8x8 Y click LED Flash 2
Viewed