Top seller
No results were found for the filter!
ccRF2 click ccRF2 click carries CC1120 , the fully integrated, high-performance single-chip radio transceiver with extremely low power consumption. Designed mainly for the ISM (Industrial, Scientific, and Medical) and SRD (Short Range Device)...
₹3,779.00 *
GPS3 click GPS3 click carries Quectel’s L80 GPS module, a high-sensitivity ultra slim GPS module with a patch antenna. The module incorporates several technologies that enhance the GPS performance. EASY™ Technology ensures that L80 can calculate...
₹4,619.00 *
BLE P click BLE P click carries the nRF8001 IC that allows you to add Bluetooth 4.0 to your device. The click communicates with the target board MCU through mikroBUS™ SPI (CS, SCK, MISO, MOSI), RDY and ACT lines, and runs on 3.3V power supply....
₹2,629.00 *
tRF click tRF click is an add-on board in mikroBUS form factor. It can be used to wirelessly send and receive UART data. It features the Telit LE70-868 - 868 MHz transceiver module with an embedded stack that is easy to integrate and use in...
₹6,199.00 *
ccRF click ccRF click is a low-power 2.4 GHz transceiver designed for the 2400- 2483.5 MHz ISM and SRD frequency bands. It features CC2500 Low-Power 2.4 GHz RF transceiver as well as PCB trace antenna. The CC2500 is integrated with a highly...
₹2,309.00 *
RFid click RFid click features CR95HF 13.56 MHz contactless transceiver as well as trace antenna. The click is designed to run on a 3.3V power supply only. It communicates with the target MCU via mikroBUS™ UART (TX, RX), SPI (MISO, MOSI, SCK, CS)...
₹3,049.00 *
IR click IR Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding infrared (IR) remote control module to your design. It features TSOP38338 IR receiver module as well as QEE113 IR emitting diode. The 38 kHz...
₹999.00 *
GSM2 click GSM2 click is the simplest way to add GSM/GPRS communication layer to your project, for fast transmission of data, voice, and SMS. It features the Quectel quad-band M95 FA GSM/GPRS module that has an integrated TCP/IP protocol stack,...
₹4,619.00 *
nRF T click nRF T Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz PCB trace antenna. The board supports an air data rate of 250...
₹1,679.00 *
nRF C click nRF C Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz SMD chip antenna. The board supports an air data rate of 250...
₹1,999.00 *
GSM Click Precision control GSM click is the easiest way to add GSM/GPRS communication to your device. The click features Telit's GL865-QUAD module. GSM click runs either on 3.3V or 5V power supply and communicates with the target microcontroller...
₹5,149.00 *
BEE click BEE click features MRF24J40MA 2.4 GHz IEEE 802.15.4 radio transceiver module from Microchip. The click is designed to run on 3.3V power supply only. It communicates with the target microcontroller over an SPI interface. BEE click is an...
₹3,049.00 *
DALI 2 click iButton click Keylock 2 Click PS 2 click 6LoWPAN C click ATA6563 click RS485 click 5V Arduino MKR RS232 SPI click 3G-AA Click DC MOTOR 3 Mikromedia 4 RS232 click Angle 4 click ETH Click OBDII click BarGraph 3 DHT22 2 click 4G LTE-APJ Heart Rate 7 Pi 4 Click NANO GPS click Counter Click IrDA 3 click UART I2C SPI Tamper 2 click 6DOF IMU click Slider click Hall Current 4 13DOF Click WiFi2 click 6LoWPAN T click GSR click RiBUS Click Pedometer 3 I2C to SPi Accel 12 click Balancer 3 Vibro Motor GPS Click LED Driver 3 RS485 4 Click SpeakUp click RS485 3 click DALI Click IR Sense 2
Viewed