ADC 2 click carries MCP3551/3, which is a 22-bit ADC with automatic internal offset and gain calibration. This high precision analog-to-digital converter has total unadjusted error of less than 10 ppm, and low-output noise of 2.5 µV RMS. The board carries two pairs of screw screw terminals: VIN- for bringing in reference voltage, VIN+ for the positive voltage. VCC out and GND are output voltages. The click communicates with the target board through mikroBUS CS, CSK and MISO lines. Can use either a 3.3V or 5V power supply.
Specification
Type
ADC
Applications
For applications where high accuracy is needed (measurements from analog pressure, temperature and humidity sensors)
On-board modules
MCP3551/3
Key Features
Input and output Screw terminals, 22-bit ADC, Voltage reference jumper (4.096V or VCC)
