Top seller
No results were found for the filter!
Hall Current 4 Click DO NOT TOUCH THE BOARD WHILE THE EXTERNAL POWER SUPPLY IS ON! Note : Voltage higher than 50V can be hazardous! The click is to be used by trained personnel only and attention when applying high voltage is strongly adviced. Due to the...
₹1,889.00 *
Temp&Hum 10 Click Temp&Hum 10 click can measure the humidity in the range from 0 to 100 %RH and temperature in the range from -30 °C to +100 °C, with the typical accuracy of ±3 %RH and ±0.4 ?. It consumes small amounts of power while in operation,...
₹1,679.00 *
3D Hall 3 Click Features such as the embedded self-test, support for the hard iron compensation, selectable power mode, 16-bit data output, a wide dynamic range of the measurement (±50 gauss), make this Click board™ a perfect choice for various IoT...
₹1,579.00 *
Pressure 8 Click MPR series sensors offer many benefits, making them ideally suited to be used on many different application designs. By featuring the MPRLS0025PA00001A absolute pressure sensor, Pressure 8 click is the perfect tool for development of...
₹2,629.00 *
ECG 4 Click Note: ECG 4 is a development and prototyping tool. It is not intended to be used for medical treatment of patients and other life-critical applications! The BMD101 SoC integrates all the necessary components, so there are very few...
₹3,679.00 *
Hall Current 5 Click The ACS733 has a precisely trimmed analog output, which changes linearly with the applied current. Its excellent galvanic isolation simplifies the application, allowing the Click board™ to be connected directly to the measured circuit....
₹1,889.00 *
Pressure 11 Click The pressure sensor contains protective gel, preventing water or humidity to damage the circuit. Additionally, it is protected from overpressure, allowing it to withstand pressure peaks up to 20x its measurement range. These features...
₹2,519.00 *
6DOF IMU 4 Click Features such as low power consumption, high precision of motion detection, high shock tolerance up to 20,000 g, a programmable full-scale range for increased accuracy, allow 6DOF IMU 4 click to be used for development of different types...
₹1,679.00 *
Thermostat 2 click The Click board™ is equipped with all the necessary elements, required to provide a reliable operation: it has a varistor across the relay output contacts, preventing excessive voltage transients, it has a flyback diode for the backEMF...
₹1,579.00 *
Pressure 9 click The DPS422 is designed with the low-power consumption in mind, has a very small size, and requires a low number of external components. These features make the DPS422 a perfect choice for an IoT or battery-powered application. Therefore,...
₹1,579.00 *
Proximity 7 click With its ability to accommodate to different light conditions especially behind a dark glass, the ADPS9930 represents an ideal solution for dimming TFT and LCD displays on various devices. Positioned behind a semi-transparent bezel, it...
₹1,469.00 *
Temp&Hum 5 click The HIH6130 sensor IC has compensation for relative humidity in the range from 10 to 90 %RH and temperature in the range from 0 °C to 50°C, yielding typical accuracy of ±3 %RH and ±0.5°C. It consumes a very low amount of power while...
₹2,939.00 *
TFT Designer mikroC PRO for 6DOF IMU 4 PS 2 click Expand 3 click ETH WIZ click MCU card with CAN SPI click RS232 2 click mikromedia for BroadR-Reach Expand 4 click mikroPascal PRO 13DOF Click Opto Encoder SPI Isolator DALI Click mikroC PRO for RS232 click LTE Cat.1-US Heart Rate 7 Accel 6 click mikroBasic PRO Matrix RGB M-Bus Master USB I2C click UART I2C SPI ETH Click GSR click Cap Touch 2 TFT Designer Nano GPS 2 3D Hall 3 Click MAGNETO click Color 2 Click Expand 2 click mikromedia Plus RS485 Isolator Vibra sense I2C Isolator 2 I2C Isolator BarGraph 3 HVAC Click IR Sense 2 MCP2542 click OBDII click
Viewed