Products from Digilent

The Pmod SF3 provides users with 32 MB of non-volatile memory through the use of Micron's NOR Flash memory ( N25Q256A ). By using the SPI protocol, users can both write to and read from the flash memory. Features: 32 MB serial NOR Flash...

The Pmod OC1 is an open collector BJT module using MMBT3904 transistors. Users can then drive high current devices (up to 200 mA) by providing logic signals from the host board. Features: Four 100mA (200mA max) MMBT3904 transistors Four...

An SMA to Alligator Clip Cable for a clean signal connection. Do you find yourself wishing that your signals were crisp, clean, and unimpeded unlike what you receive out of breadboard wires? Or perhaps do you find yourself called to a...

The Digilent Pmod NAV uses the LSM9DS1 3-axis accelerometer, 3-axis gyroscope, 3-axis magnetometer, plus the LPS25HB digital barometer to provide users with 10-DOF functionality. The Pmod NAV provides a variety of orientation related...

The Pmod PS/2 is a module that allows users to interface PS/2 style mice or keyboards with their system. By supplying a clock signal to the Pmod, users can then receive the standard 11-bit words that are sent from the attached...

Features: Angled headers for Pmod and breadboard connectivity Changes a 6-pin female header to a male header Provides easy access for test and measurement Ships in a pack of 5

The Pmod VGA provides a VGA port to any board with Pmod connectivity. The VGA port can be used to drive standard displays such as televisions and monitors. The host board must be capable of driving a fast parallel data bus in order to...

The Digilent Pmod TC1 is a cold-junction thermocouple-to-digital converter module designed for a classic K-Type thermocouple wire. With Maxim Integrated's MAX31855, this module reports the measured temperature in 14-bits with 0.25°C...

The Digilent Pmod ISNS20 is a small current sense module with a digital SPI interface. The board combines an Allegro ACS722 Hall Effect current sensor with a 12-bit analog-to-digital converter from Texas Instruments. The Pmod ISNS20 is...

The Pmod OD1 is an open drain FET module using NTHD4508 transistors. Users can then drive high current devices (up to 4.1A) by providing digital logic signals from the host board. Features: Two dual power N-FETs Comfortable drives 3.0 A...

The Pmod AMP3 uses a 2W Class-D audio power amplifier, the Analog Devices SSM2518 . Users are able to provide stereo audio through either I 2 S or TDM at a variety of sampling frequencies. The I 2 C interface can be used to configure the...

The Pmod CON4 allows users to connect their system to two RCA audio jacks. GPIO signals can be transferred in either direction through the audio jacks with jumper blocks to adjust signal routing. Features: 2 RCA audio jacks Receive and...