Products from Digilent

The Pmod CON4 allows users to connect their system to two RCA audio jacks. GPIO signals can be transferred in either direction through the audio jacks with jumper blocks to adjust signal routing. Features: 2 RCA audio jacks Receive and...

The Pmod AMP2 is a low power audio amplifier through the use of the Analog Devices SSM2377 . With digital gain options and a pop-and-click feature, users are able to drive a variety of monophonic outputs by providing a digital or analog...

The Pmod PMON1 is a power monitoring system that uses the Analog Devices AD5112 and ADM119 . By using I 2 C, users can set a reference voltage on the AD5112 to indicate what qualifies as an overcurrent condition for the ADM119. Once an...

The Digilent Pmod LS1 allows users to receive signals from multiple optical sensors, such as the popular combination of an IR LED with an IR sensor used in line-following robots. Features: Infrared light detector with on-board...

The Pmod HYGRO is a relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080 , you can determine the relative humidity of the environment with up to 14 bits of...

The Digilent Pmod DPG1 is a differential pressure gauge module. With NXP's MP3V5010DP piezoresistive transducer and Texas Instrument's ADCS7476 12-bit Analog-to-Digital Converter, you can detect when a change in pressure between the two...

The Pmod RJ45 connector modules can offer an extended wired connection between two different systems. Shipped as a pair of male and female modules, users can connect the two together with an Ethernet cable to communicate via the Ethernet...

The Pmod IOXP is an I/O expansion module powered by the Analog Devices ADP5589. By communicating with the chip through I 2 C, users can take advantage of up to 19 additional I/O pins as well as a keypad matrix decoder. Features:...

The Pmod CDC1 is a capacitative sensor that uses the Analog Devices AD7156 . By communicating with the chip via I 2 C, users can set the Pmod for an adaptive capacitance threshold that changes with the environment or set static...

The Digilent Pmod MTDS is a gorgeous 2.8" touchscreen display with a powerful on-board microcontroller that performs graphics processing tasks. The display is a capacitive touchscreen with QVGA resolution (320×240) and 2 finger...

With the Pmod Adapter for myRIO, you can now connect your myRIO to the expansive selection of Pmods offered by Digilent. With this product, users can increase the functionality of their LabVIEW projects by easily accessing the SPI, I2C,...

The Pmod SSR is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) continuous current. Features: 0-48 V blocking...