Products from Digilent

The Pmod HB3 is a 2A H-Bridge module. This module includes a separate pin header in addition to the standard 6-pin header to receive any external motor feedback signals. The H-Bridge can be driven through GPIO signals. Features: 2A...

The Pmod DA3 is a 16-bit Digital-to-Analog converter powered by the Analog Devices AD5541A . The single ended SMA output provides a clean, guaranteed monotonic analog output from the provided information given through an interface...

The Pmod RF2 adds RF communication through the Microchip ® MRF24J40 IEEE 802.15.4™ 2.4GHz RF transceiver module. By communicating with the device through SPI, users can transmit data at speeds up to 625 kbps through the ZigBee ® , MiWi™,...

The Pmod LED has four user LEDs that are individually driven through logic-level transistors. Features: 4 high-bright red LEDs Clearly visible logic level indicators Required driving current of Small PCB size for flexible designs 0.8“ ×...

The Pmod TPH offers 6 external pin headers so that users can easily test the GPIO signals passing through each of the pins. Features: 6 external test point headers Easily access and test signals passing through Small PCB size for...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD . Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the current status of a GPIO signal through a...

The Pmod DPOT is a digital potentiometer powered by the Analog Devices' AD5160. Users may set a desired resistance between 60Ω and 10kΩ by programming the chip through SPI. Features: Uses the Analog Devices AD5610 Digital potentiometer...

The Pmod NIC100 is designed to provide a complete Ethernet interface featuring the Microchip ® ENC424J600 Stand-Alone Ethernet Controller. The ENC424J600 provides integrated MAC and PHY support, so Ethernet functionality can be added to...

The Digilent Pmod DIP is a 12-pin dual in-line package (DIP) that also includes a 2×6 female Pmod header, allowing users to easily separate and process any signals traveling to and from their 12-pin Pmod. It allows for easy use of...

The Pmod DA1 is an 8-bit Digital-to-Analog Converter powered by two Analog Devices AD7303 . With simultaneous dual outputs per single input, users can perform up to four isolated tests on the analog outputs. Users may provide data to the...

The Arty Pmod Pack was designed to complement features of the Arty FPGA board, allowing users to expand project possibilities by utilizing a variety of peripheral modules! The Arty Pmod Pack includes the Pmod ACL, Pmod ALS, Pmod AMP2,...

Features: Angled headers for Pmod and breadboard connectivity Provides easy access for test and measurement Ships in a pack of 5