Products from Waveshare Electronics

Servo Driver Breakout for micro:bit, 16-Channel, 12-bit, I2C Interface. Did you encounter the PWM output limit of micro:bit when trying to make a robotic arm or whatever robot which requires lots of servo? We quite understand that...

Servo Driver HAT for Raspberry Pi, 16-Channel, 12-bit, I2C Interface. Needless to say, the Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to control a robotic arm...

MPLAB PICkit 4 In-Circuit Debugger, fast programming, increased functionality. The MPLAB® PICkit™ 4 In-Circuit Debugger/Programmer allows fast and easy debugging and programming of PIC® and dsPIC® flash microcontrollers, using the...

Speaker Module for micro:bit, makes it become a music player. Speaker expansion module designed for micro:bit, makes your micro:bit become a music player easily. Furthermore, it can also be used for Arduino development, compatible with...

Gamepad expansion module for micro:bit, plays music, powered from battery, also charges the battery. This little module adds arcade controls to your micro:bit, makes it possible to turn the micro:bit into a mini game console. There's...

Edge connector expansion board for micro:bit, breakout the I/O pins to pinheader interface. This is an edge connector expansion board designed for micro:bit, breakout the I/O pins to 2.54mm pitch pinheaders for easy use. Specifications...

Atmel-ICE Basic Kit, Powerful development tool for debugging and programming Atmel SAM and AVR microcontrollers, Comes with additional adapter and cables. Atmel-ICE is a powerful development tool for debugging and programming Atmel ARM®...

Compute Module IO Board Plus, Composite Breakout Board for Developing with Raspberry Pi CM3, CM3L. The Compute Module IO Board Plus is a development board which you can plug a Raspberry Pi Compute Module into, and make use of the...

This is an E-Ink raw display, 7.5inch, 640x384 resolution, with embedded controller, communicating via SPI interface, supports red, black, and white three-color display. Due to the advantages like ultra low power consumption, wide...

True color RGB LED HAT (B) for Raspberry Pi, colorful display, 8 × 8 grid. This RGB LED HAT (B) can be easily attached on top of the Raspberry Pi to display colorful effect, and controlled by only one signal pin. Features Supports any...

10 DOF IMU Sensor (C), Inertial Measurement Unit, Lower Power Consumption. 10 DOF IMU Sensor (C) is good at motion monitor, as well as detecting/measuring the position, height, and temperature. It would be helpful for making your own...

CP2102 USB to UART Module, USB micro connector. The CP2102 USB UART Board (micro) is an accessory board that features the single-chip USB to UART bridge CP2102 onboard. CP2102 features: Single-Chip USB to UART Data Transfer No external...