Products from Seeed Studio

This Grove-Infrared temperature sensor is a non-contact temperature measure model. The sensor is composed of 116 elements of thermocouple in series on a floating micro-membrane having an active diameter of 545μm and with blacken surface...

This is a multifunctional sensor that gives you temperature and relative humidity information at the same time. It utilizes a TH02 sensor that can meet measurement needs of general purposes. It provides reliable readings when environment...

This is a Super Capacitor Real-Time Clock module, it design for Raspberry Pi, but it also can be used to Arduino. Plugging it into Raspberry Pi GPIO interface, and all is ok. This is the easiest way to keep it in time. Compared with the...

This is a lovely momentary push button pack for your dash board or control panel. Each pack contains a set of six 12 mm colored domed push buttons. They are red, yellow, green, blue, black and white, which are great for different...

The Wireless Charging Module can be applied in electronic equipment’s in common use for close wireless charging or power supply. Consisted of a transmitter and insulation coil, it could serve as a replacement for the Wireless Power...

Hook your Arduino up to GSM/GPRS cell phone network with GPRS shield! You can use your Arduino/Seeeduino or other main boards to dial a phone number or send a text to your friend via easy to use AT commands now. GPRS Shield features a...

Seeeduino GPRS is a IoT panel, you can connect to the internet through GPRS wireless network with it. Making/answering voice calls and sending/receiving SMS messages are also supported. Meanwhile, Seeeduino GPRS supports FM radio...

Pack list: 1X Barrel jack adaptor-screw terminal to 2.1mm male 1X Barrel jack adaptor-screw pluggable terminal to 2.1mm male 1X Barrel jack to screw terminal converter 1X BNC adaptor female to screw terminal 1X DC jack to JST 2pin...

This is an embedded thermal printer, which is widely used in various occasions, such as supermarkets, convenience stores, post office, bank and so on. It is not a normal consumer product, but similar to consumer products. The compact...

Arduino Uno is the most popular Arduino board so far, however it is sometimes frustrating when your project requires a lot of sensors or Leds and your jumper wires are in a mess. The purpose of creating the Grove – Base Shield is to help...

IOIO is a board specially designed to work with your Android device. And this Grove - Base Shield for IOIO is an expansion board for IOIO to work with abundant Grove resources. There are 6 ready Grove sockets on the board covering...

The Grove – Signal Axis Analog Gyro is based on an angular velocity sensor that uses the phenomenon of Coriolis force. It can only measure the X-axis angular velocity, which is different from other 3-Axis gyro, but with a higher speed....