Products from MikroElektronika

The Gesture board, carrying Microchip’s MGC3130 3D gesture recognition controller, brings a new approach to designing intuitive user interfaces. It’s like a touchpad whose input area extends 10cm upwards into space. Users will be able to...

ECG/EMG cable with 3.5mm phone jack. 3-wire ECG/EMG cable with 3.5mm phone jack. Intended to be used with adhesive electrode pads to record electrocardiograms with ECG click , ECG 2 click or EMG click.

Analog resistive touch panel attached to the GLCD 128x64 to form GLCD Touch screen.

Type-K thermocouple with glass braid insulation is used for precision measurements of high temperatures. Thermocouple itself can measure up to 480°C (900°F). It is 2 meters long and ends with PCC-SMP connector which is compatible with...

OBD II to DB9 cable enables you to connect with your car’s OBD-II system. You just need to plug OBD II connector on one end to your car and the other end it into some sort of hardware interface which has a DB9 connector, like our OBD II...

NFC USB Dongle is an NFC Reader-Writer based on NXP’s PN7150 high-performance full NFC controller, supporting all NFC Forum modes. The USB NFC Dongle is powered through USB connector. This NFC controller supports all NFC Forum...

TFT PROTO 5" Capacitive carries the 800x480 RVT50AQTNWC00 TFT screen. The SSD1963 display controller drives the TFT display, with a 1215K byte buffer that supports up to 864x480 at 24bpp displays. The touchpanel is driven by a FT5x06...

Board features a high-current Darlington arrays ULN2803AN suitable for interfacing between a low-level logic circuitry and multiple peripheral power loads. Typical power loads with over 260 W (350 mA x 8, 95V) may have drivers turned on...

This board helps you to double the number of pins of single IDC10 PORT header, which allows you to monitor signals using oscilloscope probes while the PORT is in operation. Board is also useful when you need to connect two boards to the...

RFid Reader Board is a 125KHz RF transmitter and reciever, featuring EM4095 controller chip. The reader has three main functions: energizing, demodulation and decoding. Reader can be connected to microcontrollers or PC for encoding the...

Board features two 8-bit non-inverting bus transceiver LVXC3245. All inputs and outputs are 5V tolerant. LVCC3245 is manufactured in advanced dual metal CMOS technology. This bus transceiver contains two separate supply rails that allow...

mikroProg to ST-Link v2 adapter allows you to connect mikroProg for STM32 programmer and hardware debugger to 20-pin male JTAG connector on your target board. Adapter is consisted of one 2x10 male header and a 2x10 female socket. It’s...