Products from MikroElektronika

SmartPROTO board features female IDC10 connector and two prototyping areas which enable you place your own components and assemble an accessory board which can be connected with mikroElektronika development boards. First prototyping area...

Equip your devices with an autonomous power supply. Build solar-powered vehicles, robots or solar chargers easily. Sunlight is the cheapest energy source yet! When exposed to direct sunlight panel provides minimum of 4.0V under maximum...

The 28BYJ-48 is a small stepper motor suitable for a large range of applications. Rated voltage: 5VDC Number of Phase 4 Speed Variation Ratio 1/64 Stride Angle 5.625° /64 Frequency 100Hz DC resistance 50Ω±7%(25℃) Idle In-traction...

Thermo 7 click is a Click board™ equipped with the sensor IC, which can digitize temperature measurements between -55°C and +125°C so that the temperature measurement data can be processed by the host MCU. Thermo 7 click provides an...

VOLT is a smart USB Li-Polymer battery charger. It features power management circuitry with MCP73832 , which can charge the battery over USB connector. Using provided screw terminals (VSYS and GND) VOLT can also be used to power your...

An assortement of compatible AC plugs for all parts of the world are also sold. Reliability is paramount when it comes to power supply units . That's why we opted to carry Sunny Power Supply units . Note that power supply units are sold...

Grove - Digital Distance Interrupter 0.5 to 5cm is an infrared proximity sensor module based on GP2Y0D805Z0F. Normaly the output of this sensor is 1(High), when the object enters the measurement range of the sensor, it will be triggered...

Grove - OLED Display 0.96" is an OLED monochrome 128×64dot matrix display module with Grove 4pin I2C Interface .The characteristics of this display module are high brightness, self-emission, high contrast ratio, slim outline, wide...

Peltier Element TEC1-12706 is thermoelectric cooling element that uses the Peltier effect to create a heat flux at the junction of two different types of materials. This version is supporting 12V and current rating of 6A. Peltier Element...

The H-Bridge 5 Click is designed for control DC motors and inductiv loads. This Click board™ contains the MP6515GF-Z, a H-bridge motor driver from MPS, It features an Full H-Bridge driver with Internal safety features include...

The Peltier Click is a Click board™ which utilizes the SPV1050, an ultralow power energy harvester and battery charger from STMicroelectronics. The Peltier click can charge lithium battery using thermoelectric energy harvesting device...

MCU Card is a standardized add-on board, which allows very simple installation and replacement of the microcontroller unit (MCU) on a development board equipped with the MCU Card socket. By introducing the new MCU Card standard, we have...