Top seller
No results were found for the filter!
ccRF2 click ccRF2 click carries CC1120 , the fully integrated, high-performance single-chip radio transceiver with extremely low power consumption. Designed mainly for the ISM (Industrial, Scientific, and Medical) and SRD (Short Range Device)...
₹3,779.00 *
GPS3 click GPS3 click carries Quectel’s L80 GPS module, a high-sensitivity ultra slim GPS module with a patch antenna. The module incorporates several technologies that enhance the GPS performance. EASY™ Technology ensures that L80 can calculate...
₹4,619.00 *
BLE P click BLE P click carries the nRF8001 IC that allows you to add Bluetooth 4.0 to your device. The click communicates with the target board MCU through mikroBUS™ SPI (CS, SCK, MISO, MOSI), RDY and ACT lines, and runs on 3.3V power supply....
₹2,629.00 *
tRF click tRF click is an add-on board in mikroBUS form factor. It can be used to wirelessly send and receive UART data. It features the Telit LE70-868 - 868 MHz transceiver module with an embedded stack that is easy to integrate and use in...
₹6,199.00 *
ccRF click ccRF click is a low-power 2.4 GHz transceiver designed for the 2400- 2483.5 MHz ISM and SRD frequency bands. It features CC2500 Low-Power 2.4 GHz RF transceiver as well as PCB trace antenna. The CC2500 is integrated with a highly...
₹2,309.00 *
RFid click RFid click features CR95HF 13.56 MHz contactless transceiver as well as trace antenna. The click is designed to run on a 3.3V power supply only. It communicates with the target MCU via mikroBUS™ UART (TX, RX), SPI (MISO, MOSI, SCK, CS)...
₹3,049.00 *
IR click IR Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding infrared (IR) remote control module to your design. It features TSOP38338 IR receiver module as well as QEE113 IR emitting diode. The 38 kHz...
₹999.00 *
GSM2 click GSM2 click is the simplest way to add GSM/GPRS communication layer to your project, for fast transmission of data, voice, and SMS. It features the Quectel quad-band M95 FA GSM/GPRS module that has an integrated TCP/IP protocol stack,...
₹4,619.00 *
nRF T click nRF T Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz PCB trace antenna. The board supports an air data rate of 250...
₹1,679.00 *
nRF C click nRF C Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz SMD chip antenna. The board supports an air data rate of 250...
₹1,999.00 *
GSM Click Precision control GSM click is the easiest way to add GSM/GPRS communication to your device. The click features Telit's GL865-QUAD module. GSM click runs either on 3.3V or 5V power supply and communicates with the target microcontroller...
₹5,149.00 *
BEE click BEE click features MRF24J40MA 2.4 GHz IEEE 802.15.4 radio transceiver module from Microchip. The click is designed to run on 3.3V power supply only. It communicates with the target microcontroller over an SPI interface. BEE click is an...
₹3,049.00 *
RS485 click EERAM 3.3V CAN Isolator Voltmeter click Brushless 3 RS232 Isolator RS232 click 1-Wire I2C DHT22 2 click mikroC PRO for RS232 2 click mikroC PRO for ATA6570 click 4-20 mA R click I2C Isolator 2 NFC click LLC-I2C Click V to Hz 2 click ATA663254 click LLC SPI Click I2C Isolator mikroPascal PRO RS485 click 5V UPS click UART I2C SPI WiFi 5 click USB I2C click RS485 2 click USB UART 3 EasyLV-18F v6 AC Current mikroC PRO for RS485 4 Click GSM Click iButton click Light Temp CAN SPI click BarGraph 2 DALI 2 click MCP2517FD click ETH Click EasyMx PRO v7 RS485 3 click Heart rate 6 Accel 7 click MikroBasic PRO
Viewed