INTRODUCTION DFRobot Gravity: Analog pH meter V2 is specifically designed to measure the pH of the solution and reflect the acidity or alkalinity. It is commonly used in various applications such as aquaponics, aquaculture, and...

INTRODUCTION This AL Heat Sink(With adhesive tape) and a U.S. made 3M-8810 thermal adhesive tape on the back of the heatsink. So you don't require a coat layer of heat conduction glue on the heatsink. Just remove the blue protective film...

DFRobot Gravity: analog electrical conductivity sensor/meter(K=10) is particularly used to measure the high electrical conductivity liquid, such as seawater, concentrated brine, etc. The measurement range is up to 100ms/cm. This product...

INTRODUCTION This is a high-quality 5V USB wall adapter that is ideal for supplying power to your LattePanda, Raspberry Pi, Arduino and other 5V devices that require extra current. The higher current will charge devices faster - use it...

INTRODUCTION After several months of "Out of Stock", DS1307 RTC module has experienced a huge upgrade. It comes with a Gravity IIC interface.Its size is also reduced to fit miniaturization application. Gravity I2C DS1307 RTC module is a...

INTRODUCTION The BMI160 6-axis inertial motion sensor is a new product from DFRobot. It is based on Bosch BMI160 6-axis MEMS sensor which integrates 16-bit 3-axis accelerometer with ultra-low-power 3-axis gyroscope. Bosch BMI160 is...

INTRODUCTION Gravity: I/O Expansion Shield for OpenMV Cam M7 is an expansion shield specially designed for the OpenMV Cam M7. It is compatible with various sensors and electronic modules of Gravity series, plug and play, no soldering...

INTRODUCTION Bluno is great but I want small size for my product; Ble-link does well in its work but I don't want additional adapter to be inserted. Now, these problems are solved with BLE Micro, a new kind of bluetooth 4.0 device. Comes...

INTRODUCTION Do you want to switch lights by just shaking your hand? However, you may don't want to use a complicated and costly triple axis accelerometer . This digital shake sensor is sure to meet your needs. The digital shake sensor...

INTRODUCTION DFRobot Raspberry Pi UPS HAT is an uninterruptable power supply shield for Raspberry Pi. It can provide steady power source to Raspberry Pi for an extended period of time when the system is powered-off, by which to avoid...

INTRODUCTION This is Version 2.0 of the Xboard. The main improvement is that it now operates at 5V, making it compatible with most sensors and I2C protocol without the need of a voltage level converter. The XBoard is a unique Arduino...

INTRODUCTION This is a 2 DOF robot gripper that can be installed with 2 servos so as to control gripper opening and closing with one servo, and steering gear motion control (or rotation) with the other servo. Velocity range is 0 to 54 mm...