Electrically Isolated USB EZO™ Carrier Board Allows you to connect your Atlas Scientific circuit directly to your computer or Raspberry Pi, using standard USB drivers (for an FTDI device). Built in isolation ensures that your circuit...

Flow rate 0.5ml to 105ml/mins Accuracy +/- 1% Modes of operation Continuous dispensing Volume dispensing Constant flow rate Dose over time mode Connector 5 lead data cable Calibration Single point Supplied tubing 2 x 30.48 cm Tubing size...

This carrier board utilizes the newest isolation technology, giving us the ability to put isolation into smaller footprint circuits. The Electrically isolated EZO™ carrier board is an efficient way to connect to one Atlas Scientific...

• No wiring, no bread boards • No soldering necessary, comes fully assembled • Built in electrical isolation means that sensors won’t interfere with each other, and removes outside electrical noise that can interfere with readings. •...

• No wiring, no bread boards • No soldering necessary, comes fully assembled • Built in electrical isolation means that sensors won’t interfere with each other, and removes outside electrical noise that can interfere with readings. •...

• No wiring, no bread boards • No soldering necessary, comes fully assembled • Attach up to 5 EZO ™ devices. • Works with EZO-PMP ™, EZO-CO2 ™ and the EZO-RGB. • Built in electrical isolation means that sensors won’t interfere with each...

This carrier board is a great way to connect to an Atlas Scientific circuit neatly, eliminating the need of a bread board. The Female BNC can be replaced with a terminal block (included) if needed. • Through hole soldering ( assembly...

This breakout board comes with • (2) 4.7K resistors (used for I2C pull ups) • (2) Jumper pins and jumpers • (1) BNC connector • (1) Single row of five male header pins • This board does not come with components attached. • This board...

Specification Data input UART, I2C and SMBus Max data rate 1 MHz Output voltage 3.9V ± .07 Voltage input 3.0V − 5.0V Power saving EN pin Current consumption 5V – 15 mA 3.3V – 20 mA Circuit dimensions 13.97mm x 20.16mm (0.55″ x 0.79″)...

• Expand a single UART (RX/TX) serial port into 8 additional serial ports • On-board LEDs indicate which channel has been opened • Supports baud rates greater then 1M Baud • Easily connect two Serial Port Expanders together to get 16...

The Basic USB to Serial Converter is a very useful tool that allows you to connect your Atlas Scientific circuits to your computer. • LED’s indicate RX and TX communication • Rapid calibration and debugging • 2 different output voltages...

BNC panel mount kit comes with : • 1x Rubber gasket (choice of color) • 1x BNC bulk head • 1x Hinged cover • 1x BNC cable (male to male) • 1x Template sticker • 2x Mounting screws • 2x Brass couplings BNC cable specs : • 15.8cm (6.25") •...