The Pmod R2R is resistor ladder with a R-2R resistor configuration. Users can provide 8-bits of parallel data to the module through GPIO signals. This setup teaches users the basic principles behind a Digital-to-Analog Converter....

The Pmod TMP2 is an ambient temperature sensor powered by the Analog Devices ® ADT7420 . Through the I 2 C interface, users may appreciate a resolution of 0.0078°C through 16 bits of data. Features: 16-bit ambient temperature sensor...

The Pmod HB3 is a 2A H-Bridge module. This module includes a separate pin header in addition to the standard 6-pin header to receive any external motor feedback signals. The H-Bridge can be driven through GPIO signals. Features: 2A...

The Pmod DA3 is a 16-bit Digital-to-Analog converter powered by the Analog Devices AD5541A . The single ended SMA output provides a clean, guaranteed monotonic analog output from the provided information given through an interface...

The Pmod RF2 adds RF communication through the Microchip ® MRF24J40 IEEE 802.15.4™ 2.4GHz RF transceiver module. By communicating with the device through SPI, users can transmit data at speeds up to 625 kbps through the ZigBee ® , MiWi™,...

The Pmod LED has four user LEDs that are individually driven through logic-level transistors. Features: 4 high-bright red LEDs Clearly visible logic level indicators Required driving current of Small PCB size for flexible designs 0.8“ ×...

The Pmod TPH offers 6 external pin headers so that users can easily test the GPIO signals passing through each of the pins. Features: 6 external test point headers Easily access and test signals passing through Small PCB size for...

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD . Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the current status of a GPIO signal through a...

The Pmod DPOT is a digital potentiometer powered by the Analog Devices' AD5160. Users may set a desired resistance between 60Ω and 10kΩ by programming the chip through SPI. Features: Uses the Analog Devices AD5610 Digital potentiometer...

The Pmod NIC100 is designed to provide a complete Ethernet interface featuring the Microchip ® ENC424J600 Stand-Alone Ethernet Controller. The ENC424J600 provides integrated MAC and PHY support, so Ethernet functionality can be added to...

The Digilent Pmod DIP is a 12-pin dual in-line package (DIP) that also includes a 2×6 female Pmod header, allowing users to easily separate and process any signals traveling to and from their 12-pin Pmod. It allows for easy use of...

The Pmod DA1 is an 8-bit Digital-to-Analog Converter powered by two Analog Devices AD7303 . With simultaneous dual outputs per single input, users can perform up to four isolated tests on the analog outputs. Users may provide data to the...