The Pmod BTN gives users four momentary pushbuttons for easy user inputs to a system board. Features: Four momentary pushbuttons Debouncing filters Inverting Schmitt Triggers Small PCB size for flexible designs 1.2“ × 0.8” (3.0 cm × 2.0...

The Pmod GYRO is a 3-axis gyroscope powered by the STMicroelectronics L3G4200D . By communicating with the chip through SPI or I 2 C, users may configure the module to report angular momentum at a resolution of up to 2000 dps at an...

The Pmod DA2 is a 12-bit Digital-to-Analog converter powered by the Texas Instruments DAC121S101. As it is able to simultaneously convert two separate channels of digital information provided over an interface similar to SPI, users can...

The Pmod CON1 is a small module with six screw terminals to interface with external wires that are not compatible with the DIP standard. Two of the terminals can be used to provide power from an outside source and the other four can be...

Features: 6", 6-pin crossover cable Connects newer UART-interface Pmods (PmodBT) to older microcontroller boards (Cerebot 2, Cerebot 32MX4, etc.) Connects older UART-interface Pmods (PmodCLS, PmodRS232, etc.) to newer microcontroller...

The Pmod HB5 offers a 2A H-bridge circuit to drive small to medium sized DC motors. Two sensor feedback pins are incorporated into the motor connection header and are specifically designed to work with the Digilent motor/gearbox, which...

The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...

The Pmod RTCC is a real-time clock/calendar powered by the Microchip ® MCP79410. Through the I 2 C interface, users may configure up to two alarms that can be triggered at a wide variety of possible times. Note: The Pmod RTCC is also...

The Pmod CON3 can be easily used to interface with up to four small servo motors that deliver anywhere from 50 to 300 ounce/inches of torque, such as those used in radio controlled airplanes or cars, as well as some mechatronics...

The Pmod R2R is resistor ladder with a R-2R resistor configuration. Users can provide 8-bits of parallel data to the module through GPIO signals. This setup teaches users the basic principles behind a Digital-to-Analog Converter....

The Pmod TMP2 is an ambient temperature sensor powered by the Analog Devices ® ADT7420 . Through the I 2 C interface, users may appreciate a resolution of 0.0078°C through 16 bits of data. Features: 16-bit ambient temperature sensor...

The Pmod HB3 is a 2A H-Bridge module. This module includes a separate pin header in addition to the standard 6-pin header to receive any external motor feedback signals. The H-Bridge can be driven through GPIO signals. Features: 2A...