This IR proximity sensor can detect opaque objects within 10cm and connects to an Analog Input or VINT Hub port. This sensor can detect the presence of objects at a distance of 0 to 10cm regardless of the object reflective properties....

Single board computer running Debian 7.0 with 128 MiB SDRAM, 1 GiB Flash, integrated 1018 and 6 USB 2.0 ports. The PhidgetSBC3 is a Single Board Computer with an integrated PhidgetInterfaceKit 8/8/8. At its most basic, it can be thought...

Outputs a voltage from -10V to +10V. The PhidgetAnalog 4-Output Produces a voltage over -10V to +10V at a maximum of ±20mA. If this current is exceeded an error will be thrown to notify that the voltage may have dropped below the...

This board is needed to measure the output from a load cell. You can connect up to four load cells or strain gauges. The PhidgetBridge lets you connect up to 4 un-amplified Wheatstone bridges, such as: Strain gauges Compression load...

Read up to four encoders simultaneously with this Phidget. Includes 4 digital inputs for reading limit switches. The PhidgetEncoder Highspeed 4-Input can be used with a wide assortment of mechanical and optical encoders. The encoder...

Measure global position, velocity and heading with the Phidget GPS. Best case accuracy of 2.5m CEP. The Phidget GPS provides the longitude and latitude of the board's position in signed decimal degree format. The position accuracy (best...

Control 8 DPDT mechanical relays, switching up to 250VAC/2amp or 200VDC/2amp. The PhidgetInterfaceKit 0/0/8 provides small signal relays with 8 relay outputs, rated at a combination of 250VAC, or 2 Amps, up to a maximum of 60 Watts....

Specification Data input UART, I2C and SMBus Max data rate 1 MHz Output voltage 3.9V ± .07 Voltage input 3.0V − 5.0V Power saving EN pin Current consumption 5V – 15 mA 3.3V – 20 mA Circuit dimensions 13.97mm x 20.16mm (0.55″ x 0.79″)...

Replaced by 1012_3 Use it to check the state of switches and push buttons, and/or to switch relays, solenoids, and LEDs. Digital Inputs The Digital Inputs are activated by an external voltage source, triggering on a wide voltage range: 4...

• Expand a single UART (RX/TX) serial port into 8 additional serial ports • On-board LEDs indicate which channel has been opened • Supports baud rates greater then 1M Baud • Easily connect two Serial Port Expanders together to get 16...

The Phidgets workhorse. Connect sensors, control outputs, and read in digital inputs. Analog Inputs The analog inputs are used to measure continuous voltage outputs generated by various sensors such as temperature, humidity, position, or...

The Basic USB to Serial Converter is a very useful tool that allows you to connect your Atlas Scientific circuits to your computer. • LED’s indicate RX and TX communication • Rapid calibration and debugging • 2 different output voltages...