The Microphone AMP Board enables you to add a power amplifier with microphone to your applications. There is an on-board Audio Power Amplifier LM4864 and microphone that can be connected to your prototype device via an on-board screw...

mikroProg to ICD2 & ICD3 is an adapter board which allows you to connect mikroProg™ programmer and In-Circuit debugger to target board where only ICD2/3 connector is available for programming. Board provides the necessary interface for...

Relay 4 Board is a cost effective solution for adding relays to your device. Single ULN2803 driver IC with 8 Darlington arrays drives each of the four available relays. Screw-terminals allow you clean and easy output relay connectivity,...

SmartPROTO board features female IDC10 connector and two prototyping areas which enable you place your own components and assemble an accessory board which can be connected with mikroElektronika development boards. First prototyping area...

VOLT is a smart USB Li-Polymer battery charger. It features power management circuitry with MCP73832 , which can charge the battery over USB connector. Using provided screw terminals (VSYS and GND) VOLT can also be used to power your...