Top seller
No results were found for the filter!
Pmod LS1: Infrared Light Detector The Digilent Pmod LS1 allows users to receive signals from multiple optical sensors, such as the popular combination of an IR LED with an IR sensor used in line-following robots. Features: Infrared light detector with on-board...
₹1,349.00 *
Pmod HYGRO: Digital Humidity and Temperature... The Pmod HYGRO is a relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080 , you can determine the relative humidity of the environment with up to 14 bits of...
₹1,809.00 *
Pmod DPG1: Differential Pressure Gauge Sensor The Digilent Pmod DPG1 is a differential pressure gauge module. With NXP's MP3V5010DP piezoresistive transducer and Texas Instrument's ADCS7476 12-bit Analog-to-Digital Converter, you can detect when a change in pressure between the two...
₹2,959.00 *
Pmod RJ45: RJ45 connector (Pair) The Pmod RJ45 connector modules can offer an extended wired connection between two different systems. Shipped as a pair of male and female modules, users can connect the two together with an Ethernet cable to communicate via the Ethernet...
₹949.00 *
Pmod IOXP: I/O Expansion Module The Pmod IOXP is an I/O expansion module powered by the Analog Devices ADP5589. By communicating with the chip through I 2 C, users can take advantage of up to 19 additional I/O pins as well as a keypad matrix decoder. Features:...
₹2,129.00 *
Pmod CDC1: Capacitative Input Buttons The Pmod CDC1 is a capacitative sensor that uses the Analog Devices AD7156 . By communicating with the chip via I 2 C, users can set the Pmod for an adaptive capacitance threshold that changes with the environment or set static...
₹829.00 *
Pmod MTDS: Multi-Touch Display System The Digilent Pmod MTDS is a gorgeous 2.8" touchscreen display with a powerful on-board microcontroller that performs graphics processing tasks. The display is a capacitive touchscreen with QVGA resolution (320×240) and 2 finger...
₹6,999.00 *
Pmod Adapter for NI myRIO With the Pmod Adapter for myRIO, you can now connect your myRIO to the expansive selection of Pmods offered by Digilent. With this product, users can increase the functionality of their LabVIEW projects by easily accessing the SPI, I2C,...
₹2,469.00 *
Pmod SSR: Solid State Relay Electronic Switch The Pmod SSR is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) continuous current. Features: 0-48 V blocking...
₹3,129.00 *
Pmod CAN: CAN 2.0B Controller with Integrated... The Pmod CAN is a CAN 2.0B controller with an integrated transceiver. The embedded Microchip MCP25625 chip connects directly to the physical CAN bus and meets automotive requirements for high-speed (1 Mb/s), low quiescent current,...
₹1,799.00 *
Pmod CMPS2: 3-Axis Compass The Digilent Pmod CMPS2 is a digital compass module using Memsic's MMC34160PJ magnetometer. The local magnetic field strength can be measured in a ±16 Gauss range with a heading accuracy of 1° and up to 0.5 mG of resolution. Features:...
₹849.00 *
Pmod HAT Adapter: Pmod Expansion for Raspberry Pi The Pmod HAT Adapter makes it easy to connect Pmods to a Raspberry Pi. It supports plug-and-play functionality, only requiring that the host Raspberry Pi is booted with the Pmod HAT attached. The Pmod HAT has three 2×6 Pmod ports and...
₹2,499.00 *
Pmod NAV 9-axis Pmod VGA Video Pmod CLS Pmod KYPD Pmod TC1 K-Type Pmod MIC3 MEMS Pmod OLEDrgb 96 6-pin MTE Cable UART Crossover Pmod ACL2 Pmod TPH2 Pmod Cable Kit Pmod NIC100 Pmod HYGRO Pmod DIP DIP to Pmod SSD Pmod MAXSONAR Pmod TMP3 Pmod AQS Pmod ToF Time Pmod HAT Pmod RJ45 RJ45 Pmod CON3 R C Pmod MicroSD Pmod DA2 Two Pmod ACL 3-axis 18 Pmod Cable Pmod AMP2 Audio Pmod PMON1 Pmod AMP3 Pmod GYRO Pmod ESP32 Pmod Adapter Pmod 8LD Eight Pmod AD5 Pmod PS2 Pmod TPH 6-pin Pmod HB5 Pmod LS1 Digilent PCB Pmod RS485 Pmod BLE Pmod OC1 Open Pmod SF3 32 MB Pmod CON1 Wire Pmod CMPS2
Viewed