Top seller
No results were found for the filter!
Pmod BTN: 4 User Pushbuttons The Pmod BTN gives users four momentary pushbuttons for easy user inputs to a system board. Features: Four momentary pushbuttons Debouncing filters Inverting Schmitt Triggers Small PCB size for flexible designs 1.2“ × 0.8” (3.0 cm × 2.0...
₹769.00 *
Pmod GYRO: 3-axis Digital Gyroscope The Pmod GYRO is a 3-axis gyroscope powered by the STMicroelectronics L3G4200D . By communicating with the chip through SPI or I 2 C, users may configure the module to report angular momentum at a resolution of up to 2000 dps at an...
₹1,919.00 *
Pmod DA2: Two 12-bit D/A Outputs The Pmod DA2 is a 12-bit Digital-to-Analog converter powered by the Texas Instruments DAC121S101. As it is able to simultaneously convert two separate channels of digital information provided over an interface similar to SPI, users can...
₹1,929.00 *
Pmod CON1: Wire Terminal Connectors The Pmod CON1 is a small module with six screw terminals to interface with external wires that are not compatible with the DIP standard. Two of the terminals can be used to provide power from an outside source and the other four can be...
₹559.00 *
UART Crossover Cable Features: 6", 6-pin crossover cable Connects newer UART-interface Pmods (PmodBT) to older microcontroller boards (Cerebot 2, Cerebot 32MX4, etc.) Connects older UART-interface Pmods (PmodCLS, PmodRS232, etc.) to newer microcontroller...
₹559.00 *
Pmod HB5: H-bridge Driver with Feedback Inputs The Pmod HB5 offers a 2A H-bridge circuit to drive small to medium sized DC motors. Two sensor feedback pins are incorporated into the motor connection header and are specifically designed to work with the Digilent motor/gearbox, which...
₹1,539.00 *
Pmod TMP3: Digital Temperature Sensor The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...
₹1,249.00 *
Pmod RTCC: Real-time Clock / Calendar The Pmod RTCC is a real-time clock/calendar powered by the Microchip ® MCP79410. Through the I 2 C interface, users may configure up to two alarms that can be triggered at a wide variety of possible times. Note: The Pmod RTCC is also...
₹1,439.00 *
Pmod R2R: Resistor Ladder D/A Converter The Pmod R2R is resistor ladder with a R-2R resistor configuration. Users can provide 8-bits of parallel data to the module through GPIO signals. This setup teaches users the basic principles behind a Digital-to-Analog Converter....
₹479.00 *
Pmod TMP2: Temperature Sensor The Pmod TMP2 is an ambient temperature sensor powered by the Analog Devices ® ADT7420 . Through the I 2 C interface, users may appreciate a resolution of 0.0078°C through 16 bits of data. Features: 16-bit ambient temperature sensor...
₹1,439.00 *
Pmod HB3: H-bridge Driver with Feedback Inputs The Pmod HB3 is a 2A H-Bridge module. This module includes a separate pin header in addition to the standard 6-pin header to receive any external motor feedback signals. The H-Bridge can be driven through GPIO signals. Features: 2A...
₹959.00 *
Pmod DA3: One 16-bit D/A Output The Pmod DA3 is a 16-bit Digital-to-Analog converter powered by the Analog Devices AD5541A . The single ended SMA output provides a clean, guaranteed monotonic analog output from the provided information given through an interface...
₹3,749.00 *
Pmod DA1 Four Pmod NAV 9-axis Pmod Clip Pmod DPOT Pmod GPS GPS Pmod ISNS20 20A Pmod AD1 Two 6 Pmod Cable Pmod DA2 Two Pmod MAXSONAR Pmod I2S2 Pmod PS2 Pmod Male Right Pmod CAN CAN Pmod DHB1 Dual Pmod DA3 One Pmod OD1 Open Pmod AD2 Pmod USBUART Pmod MIC3 MEMS Pmod JSTK2 Pmod ESP32 Pmod ACL2 Pmod RS232 Pmod CON1 Wire Pmod HB3 Pmod ALS Pmod TMP3 Pmod Female Pmod PIR Pmod GYRO Pmod R2R Pmod BLE 6-pin MTE Cable Pmod MTDS Pmod CON4 RCA Pmod HYGRO Pmod DA4 Eight Pmod LVLSHFT Pmod RS485 Pmod AQS Pmod WiFi WiFi Pmod IOXP I O Pmod AD5 Pmod Adapter Pmod BTN 4 User
Viewed