The EZO-PMP Premium Tubing Kit comes with 2 meters of Saint-Gobain® Tygon tubing and 2 connectors. This tubing is the absolute best choice for use in peristaltic pumps. It exhibits exceptional chemical resistance and unaffected by a wide...

What's smaller than a Feather but larger than a Trinket? It's an Adafruit ItsyBitsy M4 Express featuring the Microchip ATSAMD51 ! Small, powerful, with a ultra fast ATSAMD51 Cortex M4 processor running at 120 MHz - this microcontroller...

The LTR390 is one of the few low-cost UV sensors available, and it's a pretty nice one! With both ambient light and UVA sensing with a peak spectral response between 300 and 350nm. You can use it for measuring how much sun you can get...

5V, 4A Switching Power Supply. This is best suitable for nvidia jetson nano developer kit Plug type: 5.5mm OD / 2.1mm ID 'coaxial' DC plug Input: 110V-220V AC Output: ~5V DC up to 4A

This is a dual mode wireless NIC module applicable for Jetson Nano, supports 2.4GHz / 5GHz dual band WiFi and Bluetooth 4.2. Specification Chip: Intel 8265AC Bands: 2.4GHz / 5GHz Speed: 300Mbps / 867Mbps WiFi protocol: 802.11ac Bluetooth...

Dedicated Cooling Fan for Jetson Nano, 5V, 3PIN Reverse-proof Category: Jetson Nano cooling fan Connector: 3PIN reverse-proof connector Spec: 5V Dimensions: 40mm×40mm×10mm

This is the FeatherWing Doubler - a prototyping add-on and more for all Feather boards. This is similar to our FeatherWing Proto except there are two! The magic of the Doubler comes when stacking a Feather and another board on top of the...

Little clicky switches are standard input "buttons" on electronic projects. These are just like our Colorful Round Tactile Button Switch Assortment, but already assembled onto a PCB - they even have a pull-up resistor installed! The pins...

This is the FeatherWing Tripler - a prototyping add-on and more for all Feather boards. This is similar to our FeatherWing Proto except there are three! The magic of the Tripler comes when you want to connect your Feather to two other...

Store your project safe and sound in this nice weatherproof box with a clear top. We picked up this box because we like the machinable ABS plastic body and tough clear polycarbonate cover, the built in weatherproof gasket seal, and the...

The BT-100 is a wideband bias tee TX Power Amplifier (PA) that draws its current from the bladeRF 2.0 micro’s SMA connectors. The BT-100 is versatile PA that is an ideal intermediary or final stage amplifier in a TX chain. bladeRF-cli...

The BT-200 is a wideband bias-tee RX Low Noise Amplifier that draws its current from the bladeRF 2.0 micro’s SMA connectors. The BT-200 is a compact LNA solution useful for substantially lowering the noise figure and substantially...