This heatsink is a great way to ensure that none of your chips overheat, and with its convenient clip and adhesive backing, installation and removal is a breeze. The clip will fit perfectly on the Virtex-5 board, or any chip measuring...

The Snips Voice Interaction Development Kits empowers users to jump start their development of voice interfaces and easily integrate the Snips AI Voice Platform with hardware. Snips runs on device, meaning all of your voice commands and...

Last week, we released the first product of the Wio Lite series , the Wio Lite W600 , which is a SAM D21 + W600 WiFi development board and it was well received by users. Today, we bring you another new product in the Wio Lite series, the...

The MXP Wire Wrap provides a large 14x21 hole prototyping area on an expansion card compatible with the myRIO Expansion Port (MXP). The MXP Wirewrap functions as an I/O breakout, with bus traces for GND, 3.3V, and 5V on either side of...

Well, you can find hundreds of WiFi shields, modules for Arduino out there. However, most of them are either unstable, either oversized or expensive. When the Arduino and wifi chips are integrated on one development board, it is another...

This is a gear motor with encoder. It is a motor with a 34:1 gearbox and an integrated quadrature encoder that provides a resolution of 11 pulse single per round giving a maximum output of 374 within one round. With an Arduino controller...

This cable is designed to extend reach of the myRIO expansion port (MXP). The MXP extender cable is perfectly suited for mounting expansion boards, such as the Pmod Adapter. Features: 34-pin male and female connectors 8" length (210±10mm)

The Digilent myDigital accessory board for the NI myDAQ and NI myRIO is designed to provide students a cost-effective, portable, and engaging platform for teaching electronics. With a myDAQ / myRIO, NI Multisim, and a myDigital, you'll...

Attention: It is ideal to use with a LattePanda V1.0 (NOT compatible with LattePanda Alpha/Delta). This is an omni-directional antenna with an IPEX connector. Its working frequency is 2.4GHz which meets most requirements of Wi-Fi...

The Digilent myProto accessory board for the NI myDAQ and NI myRIO brings all your myDAQ/myRIO's signals to breadboard connections where they can be easily accessed using simple jumper wires, and even adds several useful I/O devices. The...

2WD miniQ robotic platform is especially designed for students and hobbyists. It's versatile and small, suitable for most indoors applications. It features high quality and powerful metal gear motors which make it a speedy robot. It is...

With the Shield Adapter for NI myRIO , you can now connect your myRIO to the expansive shield options offered by the Arduino ecosystem. The Shield Adapter is designed to work with any shield that is compatible with the Arduino® Uno using...