SmartPROTO board features female IDC10 connector and two prototyping areas which enable you place your own components and assemble an accessory board which can be connected with mikroElektronika development boards. First prototyping area...

This 6-inch (15-cm) cable has 26 AWG wires and a 3-pin female JST PH-style connector that mates with the connector on 3-pin Sharp analog distance sensors, such as the 4-30 cm GP2Y0A41, the 10-80 cm GP2Y0A21, and the 20-150 cm GP2Y0A02....

Equip your devices with an autonomous power supply. Build solar-powered vehicles, robots or solar chargers easily. Sunlight is the cheapest energy source yet! When exposed to direct sunlight panel provides minimum of 4.0V under maximum...

This powerful synchronous switching boost regulator efficiently generates an output voltage of 5 V from an input voltage as low as 2.9 V while using an input current as high as 8 A. This regulator features reverse voltage protection, and...

The A-Star 32U4 Prime LV is a programmable board based on the ATmega32U4 AVR microcontroller and arranged in the common Arduino form factor. The A-Star Prime offers many additional features and improvements over competing products,...

The 28BYJ-48 is a small stepper motor suitable for a large range of applications. Rated voltage: 5VDC Number of Phase 4 Speed Variation Ratio 1/64 Stride Angle 5.625° /64 Frequency 100Hz DC resistance 50Ω±7%(25℃) Idle In-traction...

This translucent red plastic case with integrated fan is intended for use with 2x15A , 2x30A , 2x45A, and ST 2x45A RoboClaws. The case serves to protect the RoboClaw while the fan adds cooling, allowing the motor controller to deliver...

Thermo 7 click is a Click board™ equipped with the sensor IC, which can digitize temperature measurements between -55°C and +125°C so that the temperature measurement data can be processed by the host MCU. Thermo 7 click provides an...

This crimping tool can be used to crimp both male and female versions of our JST RCY connector crimp pins, JR crimp pins, Futaba J crimp pins, and crimp pins for 0.1″ housings onto 20-28 AWG wires to make custom cables. The crimping die...

This crimping tool can be used to crimp both male and female versions of Tamiya connector crimp pins, mini Tamiya connector crimp pins, JST RCY connector crimp pins, JR crimp pins, Futaba J crimp pins, and crimp pins for 0.1″ housings...

This 12 V industrial-duty (ID) linear actuator uses an acme screw drive to lift loads up to 250 kgf [550 lbs or 2500 N] and withstand static loads up to 450 kgf [1000 lbs or 4500 N] . It has a maximum speed of 16.8 mm/s [0.66″/s] at no...

VOLT is a smart USB Li-Polymer battery charger. It features power management circuitry with MCP73832 , which can charge the battery over USB connector. Using provided screw terminals (VSYS and GND) VOLT can also be used to power your...