MCP16331 INV click works as a buck-boost voltage regulator, a switching regulator topology that combines principles of the buck conversion (step-down) and the boost conversion (step-up). A buck converter outputs voltage that is smaller...

Note: Raspberry Pi is NOT included. Overview An accessories Pack (type D) to be used with Raspberry Pi. It consists of expansion board ARPI600, various sensors, and features Arduino connectivity support. Supported Pi Raspberry Pi 1 Model...

The BBC micro:bit is a credit card sized microcontroller development system, with a very simple and user-friendly visual programming interface, designed to introduce the kids to the world of embedded electronics. The micro:bit project is...

Mini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32. Features Onboard 500mA self-recovery fuse to avoid harming by short circuit Dual voltage output (3.3V/5V), easy...

The Microphone AMP Board enables you to add a power amplifier with microphone to your applications. There is an on-board Audio Power Amplifier LM4864 and microphone that can be connected to your prototype device via an on-board screw...

This is a Raspberry Pi LoRa HAT based on SX1262, covers 868MHz frequency band. It allows data transmission up to 5km through serial port. By utilizing the new generation LoRa spread spectrum modulation technology, the communication...

mikroBUS Shuttle is a small add-on board, which is intended to be used with Shuttle click , in order to expand the mikroBUS™ with additional stacking options. This small add-on board has one mikroBUS™ equipped on itself and it is...

mikroProg for AVR is a fast USB programmer. Smart engineering allows mikroProg to support 92 Atmel AVR devices in a single programmer! Outstanding performance, easy operation, elegant design and low price are it’s top features. It is...

mikroProg for Tiva is a fast programmer and hardware debugger. Smart engineering allows mikroProg to support all Tiva C Series and Stellaris ARM Cortex™-M3 and Cortex™-M4 devices from Texas Instruments in a single programmer! Outstanding...

mikroProg to ICD2 & ICD3 is an adapter board which allows you to connect mikroProg™ programmer and In-Circuit debugger to target board where only ICD2/3 connector is available for programming. Board provides the necessary interface for...

MiWi 2 click is a sub-gigahertz radio transceiver click board™, which offers a reliable FSK or OOK communication solution, with the maximum data rates of 200kbps and 40kbps, respectively. The radio transceiver module used on this click...

MiWi click is a subgigahertz radio transceiver click board™, which offers a reliable FSK or OOK communication solution, with the maximum data rates of 40kbps and 16kbps, respectively. The radio transceiver module used on this click...