Flow rate 0.5ml to 105ml/mins Accuracy +/- 1% Modes of operation Continuous dispensing Volume dispensing Constant flow rate Dose over time mode Connector 5 lead data cable Calibration Single point Supplied tubing 15.24 cm Tubing size Any...

Reads RGB (24-bit) CIE (xyY) LUX (0 – 65535) Proximity (2 – 36cm) Features programmable color matching proximity triggering onboard LEDs Connector 5 lead data cable Response time 400ms Sensing area 15° half angle Cable length 1 meter...

Electrically Isolated USB EZO™ Carrier Board Allows you to connect your Atlas Scientific circuit directly to your computer or Raspberry Pi, using standard USB drivers (for an FTDI device). Built in isolation ensures that your circuit...

Flow rate 0.5ml to 105ml/mins Accuracy +/- 1% Modes of operation Continuous dispensing Volume dispensing Constant flow rate Dose over time mode Connector 5 lead data cable Calibration Single point Supplied tubing 2 x 30.48 cm Tubing size...

Add 16 isolated active-high digital inputs to your hub at the cost of only one VINT port. If you need to read a whole bunch of logic-level signals, this input module adds sixteen active-high digital inputs using just one port on your...

This compact Stepper Phidget gives you control of one bipolar stepper motor from a port on your VINT hub. If you're looking for a compact solution for controlling a medium-sized stepper motor, the STC1001 is an affordable and convenient...

Control two DC motors from one VINT port with this compact motor controller. The DCC1003 gives you complete control of two DC motors of up to 4 amps each from one of the ports on your VINT hub . You can control motor velocity,...

This carrier board utilizes the newest isolation technology, giving us the ability to put isolation into smaller footprint circuits. The Electrically isolated EZO™ carrier board is an efficient way to connect to one Atlas Scientific...

Measure up to 30 amps DC or ±30 amps AC with this current sensor. Connects to an Analog Input or VINT Hub port. The 1122 measures AC current up to 30 Amps and DC Current from -30Amps to +30Amps. Dual outputs allow the user to measure...

This simple and affordable quadrature-output encoder fits onto the rear shaft of a motor so its position and velocity can be monitored. There are so many projects that require motor position control that Phidgets decided to make an...

• No wiring, no bread boards • No soldering necessary, comes fully assembled • Built in electrical isolation means that sensors won’t interfere with each other, and removes outside electrical noise that can interfere with readings. •...

Control a single DC motor up to 4A with this compact and affordable Phidget. Connects to a VINT port. The DCC1002 gives you complete control of one medium to large DC motor from one of the ports on your VINT hub . You can control motor...