The PCA9306 I2C Level Shifter is a complete level and power shift solution for I2C communications. The input side of the PCA9306 accepts a I2C communication voltage as well as a power supply voltage from 0.3 to 5VDC. The output side of...

The P82B715TD I2C Range Extender Signal Conditioner is designed to extend the effective range of the I2C Bus from a few feet to a guaranteed minimum of 100 ft when using compatible cable* with a maximum operating speed of 400KHz. We ship...

ZigMo_PCB ZIGMO Wi-Fi/Bluetooth Configuration Kit Configure Passwords of Wi-Fi & Bluetooth Modules NCD Exclusive USB Connectivity for More Reliable Communication Easy KFX Key Fob Configuration Use the ZigMo_PCB to configure KFX Key Fob...

About Key Fob Relays Our 2nd generation Key Fob Series controllers allow users to control relays from a hand-held remote up to 750 feet away! Configure buttons to toggle relays, turn relays on and off, activate timers and control relay...

– External antenna – RF cable assemblies RP-SMA (Female) JK-IPEX MHF U.FL 1.13 100MM – RP-SMA (Male) Tilt Swivel 1/2 Wave Whip antenna NOTE: Using the LoRa/Sigfox radio without the external antenna can lead to damage of the device and is...

This is a 3″ Pigtail antenna adapter with a U.fl connector on one side an a RP-SMA connector on the other. This is typically used to connect NCD communication modules to antennas.

ZigBee Wireless Communication Mesh Networking is simply the hottest wireless technology of our time. Period. It’s fast, it’s very easy to use, highly reliable, and self healing. Three components are required for the ZigBee Mesh Network,...

802.15.4 Wireless Modem 802.15.4 Modem make Wireless Control EASY Plug In, Open the COM Port and Start Sending Commands Wireless Control is as Easy as Talking to a USB Port on Your Computer! Wireless Communication Communicating with a...

900HP-S3B Wireless Modem 900HP-S3B Modem make Wireless Control EASY Plug In, Open the COM Port and Start Sending Commands Two Miles of Wireless Control From the USB Port on Your Computer! Wireless Communication Communicating with a...

The RSIO-F6 includes a small RSIO circuit board with a DB-9 Female RS-232 Connector and a 6″ (152mm) flexible ribbon cable. The RSIO-F6 also includes a 2.1mm center positive power supply connector. The RSIO-F6 is used with a few of our...

The RSIO includes a small RSIO circuit board with a DB-9 Female RS-232 Connector and a set of 5 prongs for connection to many of the Legacy Series controllers. The RSIO also includes a 2.1mm center positive power supply connector. The...

The RSB Serial Booster was designed to drive up to 20 optoisolated NCD devices from a single RS-232 serial port with a DB9 connector. The RSB has been tested to drive RS-232 signals at 1000+ feet at data rates up to 38.4K baud. Simply...