Grove - EL Driver is designed for driving EL Wires.It integrates a very small inverter to drive the EL Wire, so you can easily light up the EL Wire with just one single Grove cable. Features: Grove compatible interface 3.3V/5V Compatible...

Temperature and Humidity (T&H) remain top on the list for DIY Maker projects' sensing needs, many T&H sensors are constructed from thermistor / low priced capacitive humidity sensor are not accurate for serious projects. This Temperature...

The Downgrade module is specifically designed for RaspberryPi Module B+. As we know the Module B+ has more GPIO that resulting in some of the original for accessories may not be used on Module B+. So, the Downgrade module can make the...

DevDuino Sensor Node V2 is a compact Arduino-compatible microcontroller and is designed to build wireless networks based on transceiver nRF24L01+ . You can easily connect other sensors or actuators to this platform, to build your remote...

The DA/AD module is specifically designed for RaspberryPi. It communicated with RaspberryPi through I2C bus. There is a LED light on the board that you can adjust brightness through DA. The module supply 4 ADC channel through header on...

The LDT0-028K is a flexible component comprising a 28 μm thick piezoelectric PVDF polymer film with screen-printed Ag-ink electrodes, laminated to a 0.125 mm polyester substrate, and fitted with two crimped contacts. As the piezo film is...

This module based on Nordic nRF24L01, highly integrated, ultra-low power (ULP) 2Mbps RF transceiver for the 2.4GHz ISM (Industrial, Scientific and Medical) band. Nordic nRF24L01+ integrates a complete 2.4GHz RF transceiver, RF...

The H3LIS331DL is a low power high performance 3-axis linear accelerometer belonging to the “nano” family, with digital I2C serial interface standard output. The device features ultra-low power operational modes that allow advanced power...

This is a DC/DC step-down voltage regulator that converts input voltage between 4.5V and 16V into a smaller voltage between 1V and 12V, capable of driving a 1.5A load with excellent line and load regulation. In some projects, you might...

This module is based on 2-Coil Latching Relay. Contrast to the ordinary relay, this latching relay do not need continuous power to keep the state, only a rising/falling pulse is needed to change the work state. Even the power can be...

This Wireless Charging Module is an inductive wireless charging module suitable for any electronic projects requiring 5V supply. It comes with two coils – a transmitter coil and a receiver coil. The transmitter coil needs to be connected...

This G1/2 micro hydro generator provides you clean and renewable electricity. With the help of the regulator circuit inside, the output of this generator is stable at 3.6V. And the capacity of battery is improved from 300mAh to 700mAh...